AIC XD1100-1102 Manual de usuario descargar pdf (Pagina 15)

1U10 RBOD User’s Manual

2.4.1. Removing an IO Module

1) Remove any external cables connected to the module.

2) Turn the thumbscrews counterclockwise and pull out to release the IO module tray and

then pull gently.

3) Pull module firmly until it clears the enclosure chassis and place in anti-static bag or

container prior to storage or shipment.

2.4.2. Installing an IO Module

1) Remove any packing material and cover.

2) Align the IO module tray with the opening in the rear of the enclosure. Slide in until

module connector engages mating connector on backplane.

3) Firmly seat the module and backplane connectors until handle is fully latched and lock

the thumbscrews.

4) Connect cables to expander. If system is operational during installation, the Expander

will self test and begin FC/SAS link initialization.

2.5. Removing and Installing a PSU Module

This section describes removing and installing a PSU Module.

Figure 2.4: 1U 10-Bay RBOD PSU

Warning: Electro-Static Discharge, ESD, can damage the Expander and other electronic

elements of the system without exhibiting physical signs of damage. Proper grounding and

protective steps should be employed when handling any ESD sensitive materials or devices.

Handle Expander Tray. Avoid touching expander board or components. Failure to follow proper

ESD protective procedures may result in equipment damage or failure.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 71 72

Sin comentarios

AIC XD1100-1102 Manual de usuario Pagina 15